Cooper-instruments-systems DFI Infinity CS Economy Digital Indicator Manual do Utilizador descarregar pdf (Página 12)

DFI INFINITY CS (V- M3598/N/0906) 9 CF 70

Table 3-1 S3 Jumper Functions

3.3 Panel Mounting

Figure 3-4 Meter – Exploded View

1. Cut a hole in your panel, as shown in Figure 3-4. For

specific dimensions refer to Figure 3-5.

2. Insert the meter into the hole. Be sure the front bezel

gasket is flush to the panel.

3. Slide on mounting bracket to secure.

4. Proceed to Section 3.4 to connect your sensor input

and main power.

NOTE: Dimensions in Millimeters (Inches)

Figure 3-5 Panel Cut Out

3.4 Connecting Sensor Inputs

Figure 3-6 shows excitation supplied from the meter’s internal supply (50mA maximum). Select 5,10, or 12 volt

excitation at DIP switch.

Jumper Description

S3-A

Install to enable front panel push buttons.

Remove to disable all front panel push-buttons

S3-B Removed. For factory calibration only.

S3-C Removed. Not Used

S3-D Installed for external ratiometric.

S3-E If installed without S3-B, the MENU button locks out. If you

press the MENU button, the meter shows

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sem comentários

Cooper-instruments-systems DFI Infinity CS Economy Digital Indicator Manual do Utilizador Página 12